buttons AUDI A4 1995 B5 / 1.G APB Engine Additional Signals Checking Workshop Manual
Page 8 of 37
24-185
Brake light switch -F and brake pedal
switch -F47, checking
- Connect vehicle diagnostic, testing and
information system VAS 5051 or VAG1551 scan
tool and select engine electronics control
module by entering address word "01" Page
01
-9 .
When doing this the ignition must be switched
on. Rapid data transfer
HELP
Select function XX
Indicated on display
- Press buttons -0- and -8- to select function "Read Measuring Value
Block" and confirm entry with -Q- button.
Read Measurin
g Value Block
Input displa
y group number XXX
Indicated on display
- Press buttons -0-, -6- and -6- to select "display group number 066" and
confirm entry with -Q- button.
Pa
ge 8 of 37 Additional si
gnals, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.6
Page 15 of 37
24-191
Clutch Vacuum Vent Valve Switch -F36,
checking
Note:
This signal is used to avoid RPM over-oscillation
and load change impacts when changing gears
and is also used for the cruise control system.
Test sequence
- Connect vehicle diagnostic, testing and
information system VAS 5051 or VAG1551 scan
tool and select engine electronics control
module by entering address word "01" Page
01
-9 .
When doing this the ignition must be switched
on. Rapid data transfer
HELP
Select function XX
Indicated on display
- Press buttons -0- and -8- to select function "Read Measuring Value
Block" and confirm entry with -Q- button.
Read Measurin
g Value Block
Input displa
y group number XXX
Indicated on display
- Press buttons -0-, -6- and -6- to select "display group number 066" and
confirm entry with -Q- button.
Read Measuring Value Block 66
Indicated on display
Pa
ge 15 of 37 Additional si
gnals, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.6
Page 28 of 37
24-202
Checking bus system
The principle of the test is independent of the
number of control modules/systems connected to
the CAN-bus.
The DTC table suggested checking the data
exchange between the Engine Control Module
(ECM) and CAN capable control modules.
- Start engine (if engine will not start, switch
ignition on).
- Connect VAS5051 tester or VAG1551 scan tool
and select the control module for engine
electronics using "address word" 01 Page 01
-
9 .
Rapid data transfer
HELP
Select function XX
When indicated on display:
- Press buttons -0- and -8- to select "Read Measuring Value Block" and
press -Q- button to confirm input.
Read measurin
g value block
Q
Enter displa
y group number XXX
When indicated on display:
- Press buttons -1-, -2- and -5- to select "display group number 125" and
press -Q- button to confirm input.
Pa
ge 28 of 37 Additional si
gnals, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.6