diagram AUDI A4 1995 B5 / 1.G APB Engine Evaporative Emission Syst
Page 3 of 6
24-136
Checking voltage supply to Evaporative
Emission (EVAP) Canister Purge Regulator
Valve (solenoid valve)
Note:
The Evaporative Emission (EVAP) Canister
Purge Regulator Valve receives its power supply
via the fuel pump relay.
Test requirements
Fuse for EVAP valve OK
- Disconnect harness connector on Evaporative
Emission (EVAP) Canister Purge Regulator
Valve -N80.
The diode test lamp should light up.
If diode test lamp does not light up:
Electrical Wiring Diagrams, Troubleshooting & Component Locations - Connect VAG1527 diode test lamp between engine Ground (GND) and
socket 1 on connector.
- Operate starter.
- Check continuity of wiring from socket 1 to fuel pump relay via fuse.
Repair open circuit if necessary.
Pa
ge 3 of 6 Eva
porative Emission
(EVAP
) system, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.3
Page 6 of 6
24-138
If the diode test lamp lights up continuously:
If the diode test lamp does not flash:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
If no short circuit or open circuit is found - Check for short circuit to Ground (GND) in wiring between contact 2 on
EVAP valve harness connector and socket 64 on test box.
- Check for open circuit as well as short circuit to B+ in wiring between
contact 2 on EVAP valve harness connector and socket 64 on test box.
Resistance in wiring: max. 1.5 ohm- If necessary, repair short circuit to Ground (GND) or open circuit.
- Replace Motronic Engine Control Module (ECM) -J220 Page 24
-24
.
Pa
ge 6 of 6 Eva
porative Emission
(EVAP
) system, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.3