AUDI A4 1995 B5 / 1.G AWM Engine Secondary Air System Owner's Manual

26-60

Check voltage supply for secondary air
injection pump motor

- Remove sound insulation -arrows-.

- Disconnect connector from Secondary Air Injection (AIR) Pump motor -
V101- (-arrow-).
Location: Right front in engine compartment below air filter housing
Pa
ge 21 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-61


If LED does not flash:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder
If no malfunction is found: - Connect voltage tester VAG 1527 B between contacts 1 and 2.
- Initiate output Diagnostic Test Mode (DTM) and activate Secondary Air
Injection (AIR) Pump relay -J299-.

LED must flash.
- Carry out following tests:
- Check wiring connection from contact 1 of connector to secondary air
injection pump relay (in 3-pin relay carrier in electronic box (plenum
chamber), for open circuit.
- Check wiring connection of contact 2 of connector to Ground for
open circuit: - Replace Secondary Air Injection (AIR) Pump motor -V101-.
Pa
ge 22 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-62

Combination valve for secondary air
inlet, checking function and for leaks


Special tools and equipment

Test requirements:
Test sequence
Vacuum hand pump VAG 1390Vacuum lines and hose connections do not leak. Vacuum lines not blocked.

- Remove engine cover -arrows-.
Pa
ge 23 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-63


- Remove vacuum hose -arrow- from combination valve.
- Connect hand vacuum pump VAG 1390 to vacuum unit of combination
valve.

If the combi valve does not open: - Disconnect hose -arrow- to combination valve for secondary air inlet.
- Blow into line with slight pressure (do not use compressed air).
Combi valve must be closed; blowing through must NOT be possible.
- Actuate hand vacuum pump.Combi valve must open; blowing through must be possible
- Replace combination valve Page 26
-64
.
Pa
ge 24 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-64

Combination valve for secondary air
inlet, removing and installing


Removing

- Remove engine cover -arrows-.

- Disconnect hoses -1- and -2- from combination valve.
- Unbolt combination valve -arrows-.
Pa
ge 25 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-65

Installing
Installation is carried out in the reverse order of
removal; note the following:

Note:
Replace gaskets and seals.

Tightening torque

Component
Nm
Combination valve for secondary air inlet at
cylinder head
10
Pa
ge 26 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2