lock AUDI A4 1996 B5 / 1.G 01A Transmission Selector Mechanism Assembly Workshop Manual
Page 2 of 10
34-80
Note:
For the installation position of the complete selector
mechanism in transmission Fig. 6
.
1 -
Gear lock 5th and reverse gear
Removing and installing Page 34
-86
2 -
Torx bolt
10 Nm (7 ft lb)
3 -
O-ring Always replace
4 -
Right stop bolt 40 Nm (30 ft lb)
5 -
Sealing washer
6 -
Relay shaft
7 -
Sealing washer
8 -
Left stop bolt 40 Nm (30 ft lb)
9 -
Shift detent
10 -
Torx bolt 25 Nm (18 ft lb)
Pa
ge 2 of 10 Transmission selector mechanism, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.7
Page 8 of 10
34-86
Removing and installing gear lock for 5th and
reverse gear
- Remove heat shield (arrow -2-) above right drive axle.
- Detach heat shield (arrow -1-) above right drive axle and pivot
downward.
- Remove gear lock (arrow).
Pa
ge 8 of 10 Transmission selector mechanism, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.7
Page 9 of 10
34-87
Assembling gear lock
- Insert spring -1- into housing -2- and, while applying light pressure, turn
spring to left until it locates in base of housing.
- Insert bushing -3- onto spring so bent end of spring locates into groove
properly.
- Push bushing against spring and turn approx. one turn to left, until lug
on bushing aligns with groove in housing.
- Press lug of bushing into groove in housing onto stop.
- Turn bushing to right and release.
The bushing will spring into the correct position
Installation position of bushing:
Checking installation position: - Lug (arrow -A-) of bushing must always face away from groove in
housing (arrow -B-).
- Turn bushing to left and release.
The bushing should spring back into position; the lug must be against
the stop (direction indicated by arrow -A-)
Pa
ge 9 of 10 Transmission selector mechanism, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.7
Page 10 of 10
34-88
Installation position of complete gear lock in transmission:
The recess (arrow -A-) faces bolt (arrow -B-)
Pa
ge 10 of 10 Transmission selector mechanism, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.7