check engine AUDI A4 1996 B5 / 1.G AFC Engine Assembly Workshop Manual

10-11

Installing

The engine is installed in the reverse order of
removal, with the addition of the following special
conditions and steps:

WARNING!

Do not re-use any fasteners that are worn or
deformed in normal use. Many fasteners are
designed to be used only once and become
unreliable and may fail when used a second
time. This includes, but is not limited to, nuts,
bolts, washers, self-locking nuts or bolts,
circlips and cotter pins. Always follow
recommendations given in this publication.
Always replace these fasteners with new
parts.

- Check that alignment sleeves for centering
engine and transmission are properly installed in
cylinder block. Install sleeves if necessary.

- Always install new seals and gaskets.

- Check centering of clutch disc, if necessary.

- Check clutch release bearing for wear and
replace if necessary.

Pa
ge 15 of 20 En
gine, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.10.1

10-12

- Allow stop of torque support to move down onto
rubber block under its own weight; tighten bolts
to 45 Nm (33 ft lb).

- Align exhaust system free of stress Repair
Group 26.
- Adjust accelerator pedal cable Repair Group
20.
- Re-fill engine cooling system Repair Group
19.
- Drained coolant may only be re-used provided
the cylinder block or the cylinder head was not
replaced.

- Check oil level before starting engine.

- Short blocks are supplied without bushing in
crankshaft. For vehicles with automatic
transmission, tap bushing into place before
installing drive plate.

- Check reconditioned engines with manual
gearbox to determine whether needle bearing is
installed in crankshaft; install if necessary.
Pa
ge 17 of 20 En
gine, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.10.1