stop start AUDI A4 1996 B5 / 1.G AFC Engine Auxiliary Input Signals Checking Workshop Manual
Page 6 of 37
24-91
Checking
- Start engine and let idle.
- Switch A/C on, push "AUTO" button, set
temperature to "LO" and blower speed to "HI".
A/C compressor symbol must light up and
A/C must run.
- Using VAG 1551 scan tool, select "Basic
Setting" function 04, display group 004 page 01
-150
.
A/C compressor must stop (visual check)
If the A/C compressor does not shut off:
- Switch A/C off (press "minus" button for fresh air
blower in A/C control head repeatedly, until all
indicators are off).
Continue to let engine run in idle.
- Using VAG 1551 scan tool, select "Read
Measuring Value Block" function 08, display
group 004.
Pa
ge 6 of 37 Auxiliar
y in
put si
gnals, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.24.25
Page 16 of 37
24-96
- Switch Fluke 83 multimeter to voltage
measurement range and connect between
signal wire (trip computer 20-pin connector) and
Ground (GND), using wiring diagram.
- Start engine and let idle.
Specified value: approx. 0.3 to 0.6 volts,
corresponding to engine speed (RPM)
- Vary engine speed continuously from 1000 to
4000 RPM.
Specified value: approx. 0.3 to 0.6 volts,
corresponding to engine speed (RPM)
If the specified value is not obtained, even
though the trip computer shows no consumption
value or there is a stored malfunction in the
TCM:
- Stop engine (switch ignition off).
- Replace trip computer and/or TCM as
required.
If the specified value is not obtained:
Pa
ge 16 of 37 Auxiliar
y in
put si
gnals, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.24.25