checking oil AUDI A4 1996 B5 / 1.G AFC Engine Ignition Coils Checking Workshop Manual
Page 1 of 4
28-16
Ignition coils, checking
Notes:
Check wiring between power output stage and
ignition coils, and between the ignition coils and
the connector set in the connector bracket, for
insulation damage.
Component locations page 28
-1 .
Checking secondary resistance
- Disconnect ignition wires from the ignition
coils.
If the specified resistance is not obtained for any one coil: - Switch Fluke 83 multimeter to resistance range and connect between
the two posts of the ignition coil being tested.
Specified value: 9000-14000 - Replace ignition coil.
Pa
ge 1 of 4 I
gnition coils, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.28.4
Page 2 of 4
28-17
Checking primary resistance
- Disconnect power output stage harness
connector page 28
-7 .
- Check connectors for loose, corroded terminals
or terminals that have been pushed out of their
connector housing, and repair as necessary.
Note:
The connector sequence in the connector
bracket is immaterial because all three B+
terminals route to the ignition coils.
- Connect one multimeter test leads between ignition coil connector
terminal in connector bracket...
... and 3-pin power output stage connector (for each coil).
Specified value: max. 5.0
Pa
ge 2 of 4 I
gnition coils, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.28.4
Page 4 of 4
28-18
Checking voltage supply
Fuse for ignition coils OK
- Disconnect white connector on connector
bracket page 28
-1 .
- Switch ignition on.
If the specified values are not obtained: - Switch Fluke 83 multimeter to voltage range and connect in sequence
between Ground (GND) and all three terminals of the connector.
Specified value: approx. battery voltage
- Check for open circuit using wiring diagram, repair as necessary, also
check fuses.
Pa
ge 4 of 4 I
gnition coils, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.28.4