AUDI A4 1996 B5 / 1.G AFC Engine On Board Diagnostic Multiport Fuel Injection User Guide

01-7

VAG 1551/1552 Scan Tool (ST),
connecting and selecting Engine
Electronics address word 01


Fuses for engine electronics OK
Fuel pump relay OK
Ground connections OK page 01
-5

Connecting-m.y. 1996
- Open back seat ash tray (center console) and remove cover for data
link connector.

- Connect VAG 1551/1552 scan tool with adapter cable VAG 1551/3 to
data link connector.
Pa
ge 11 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-8

Connecting-m.y. 1997
Note:
The DLC is located below the driver's knee bar to
the left of the steering wheel.

All vehicles - Connect VAG1551 or VAG1552 Scan Tool (ST) with VAG1551/3
adapter to Data Link Connector (DLC).
V.A.G On Board Dia
gnostic
(OBD
) HELP
1 - Rapid data transfer2 - Blink code output

Indicated on display1) 1) Operating modes 1 and 2 are displayed alternately.
Notes: If there is no display, check voltage supply for data link connector:
Pa
ge 12 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

Electrical Wiring Diagrams, Troubleshooting & Component Locations Additional operating instructions can be obtained by using the VAG
1551 scan tool HELP button. The button is used to advance to the next program step.
Pa
ge 13 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-9

For the function:

02: Check DTC
Memory - Let engine idle, or, crank
engine with starter for at
least 5 seconds without
switching ignition off
03: Output
Diagnostic
Test Mode - Switch ignition on
04: Basic Setting
- Let engine run or switch
ignition on
07: Code Control
Module - Switch ignition on
08: Read
Measuring
Value Block - Let engine run or switch
ignition on

- Switch printer on with PRINT button (indicator
light in the button lights up).

- Press button -1- for "rapid data transfer"
operating mode.
Rapid data transfer
HELP
Insert address word XX

Indicated on display
Note:
After inserting address word 00 and pressing -Q- button to confirm input,
Pa
ge 14 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

an automatic test sequence is carried out (checks DTC memory of all
systems with rapid data transfer).
- Press buttons -0- and -1- to insert the "Engine Electronics" address
word 01.
Pa
ge 15 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-10

Rapid data transfer
Q
01 - Engine Electronics

Indicated on display
- Press -Q- button to confirm input.
Rapid data transfer Scan Tool sends address word 01

Indicated on display
_________________________________________________________
Rapid data transfer
HELP
Control module does not answer

If the following is shown on the display:
Notes:
Electrical Wiring Diagrams, Troubleshooting & Component Locations - A list of possible malfunction causes can be printed out by pressing the
HELP button.
Check data link connector/engine control module wiring connection:Engine control module faulty Diagnostic Trouble Code (DTC) table,
page 01
-26
.
Rapid data transfer
HELP
Error in communication link

If the following is shown on the display:
Notes:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
On vehicles with several On Board Diagnostic (OBD) systems, check
wiring connection between the individual systems: For vehicles with only MFI (Engine Electronics) On Board Diagnostic
Pa
ge 16 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

(OBD) capability, the engine control module is faulty Diagnostic
Trouble Code (DTC) table, page 01
-26
.
Pa
ge 17 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-11

Rapid data transfer
HELP
K wire not switching to Ground

If one of the following two problems is shown on the display
Rapid data transfer HELPK wire not switching to B+

Note:
Check data link connector/engine control module wiring connection:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
_________________________________________________________ - A list of possible malfunction causes can be printed out by pressing the
HELP button. - After the malfunction cause is repaired, insert address word 01 again
and press -Q- button to confirm input.
8D0906266 2.8l V6/2V MFI OBD2
D01
Codin
g 01051
WSC 06388

The control module identification and the coding are shown on the
display:
Engine control module replacement part no. 8D0906266
For current engine control module version Parts catalog
Engine displacement: 2.8 liters Engine construction type: V-engine, 6-cylinderValves per cylinder: 2 valvesFuel injection system: Multiport Fuel Injection (MFI)Engine control module software version: OBD2, EPROM-status
Pa
ge 18 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

of control module
Pa
ge 19 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-12

Engine control module hardware and software
version: D_ _ Control module program status
Engine control module coding: 01051
Diagnostic Trouble Code (DTC) table, page 01
-247
.

VAG plant number: WSC 06388 (where the
VAG 1551 scan tool was used for the last
coding and/or adaptation)

Notes:
If the engine control module version that
corresponds to the vehicle is not displayed,
replace engine control module page 01
-265
.
Incorrect engine control module coding leads to:

Driving performance problems (jerky shifting,
abrupt load change, etc.)
Increased fuel consumption
Elevated exhaust gas values
Reduction in transmission service life

Pa
ge 20 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1