maintenance AUDI A4 1996 B5 / 1.G AWM Engine Lubrication System Components Workshop Manual
Page 1 of 35
17-1
Lubrication system
components, removing and
installing
Note:
If large quantities of metal shavings or particles
are found in the engine oil when repairing the
engine, all oil passages must be cleaned
carefully, and the oil cooler replaced in order to
prevent further damage occurring later.
The oil level must not be above max. mark on
dipstick - danger of damage to catalytic
converter!
Oil spray jet and pressure relief valve Fig.
1 , Page 17
-6
Viscosity grades and oil specifications:
Repair Manual, Maintenance
Oil system capacity:
Repair Manual, Maintenance
Pa
ge 1 of 35 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.17.1
Page 9 of 35
17-9
Repair Manual, Maintenance
17 -
Oil pressure switch -F1-, 1.4 bar - 25 Nm
Black insulationChecking Page 17
-30
18 -
Sealing ring
If seal is leaking, cut open and replace
19 -
15 Nm +
1/4 turn (90 ) further
Always replace
20 -
Gasket Always replaceEngage in projections on oil cooler
21 -
Oil filter Observe change intervalsObserve installation instructions on oil filterTighten to 20 Nm
Pa
ge 9 of 35 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.17.1
Page 34 of 35
17-34
Engine oil
The engine is filled with a high quality multigrade
oil at the factory. This oil may be used all year
round, except in extremely cold climates.
Viscosity grades and oil specifications
Viscosity grades and oil specifications:
Repair Manual, Maintenance
Pa
ge 34 of 35 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.17.1