fuse AUDI A4 1996 B5 / 1.G AWM Engine Secondary Air System Workshop Manual

26-46


Fig. 3 Installation position Secondary Air Injection (AIR) Pump
relay -J299-
In E-box in plenum chamber
1 - Engine control module
2 - Secondary air pump relay -J299-
3 - Power supply relay for Motronic -J271-
4 - Fuse S130 for secondary air pump

Fig. 4 Combination valve for secondary air injection
Right rear on cylinder head
Pa
ge 6 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-51

Checking power supply

Note:
The power supply for the secondary air injection
solenoid valve -N112- is via the fuel pump relay.

Test requirements:

Fuse for secondary air injection solenoid
valve OK.

Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder

Fuel pump relay OK.

Repair Manual, 1.8 Liter 4
-Cyl. 5V Turbo Fuel
Injection & Ignition, Engine Code(s): AWM, Repair Group 24


- Disconnect connector from valve.

- Connect voltage tester VAG 1527 B as follows:Connector
Measure to
Pa
ge 11 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-52
If the LED does not light up:

- Check wiring from contact 1 on the connector
via the fuse to the fuel pump relay for an open
circuit:

Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder
- Repair open circuit, if necessary
If the LED lights up:

- Check actuation.

Checking actuation

- Connect voltage tester VAG 1527 B to contacts 1 (positive) and 2 of
connector.
- Initiate output Diagnostic Test Mode (DTM) and activate secondary air
injection solenoid valve -N112-.

LED must flash.
Pa
ge 13 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-56

Check voltage supply of secondary air
injection pump relay

- Switch ignition off.

- Remove secondary air injection pump relay.

If specified value is not attained: - Connect multimeter as follows to measure voltage.3-position relay carrier in E-box in plenum chamber,
position 2
Contact
Measure to

8 Engine
Ground
Specified value: approx. battery voltage
- Carry out following tests:

- Check fuse S130 (40 A) in electronics box of plenum chamber, (Pos.
4).
Pa
ge 17 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-57

- Check for open circuit in wiring from battery +
(terminal 30) to fuse S130 for secondary air
injection pump relay (in 3-position in E-box of
plenum chamber, position 2).

Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder

If specified value is not attained: - Connect multimeter as follows to measure voltage.3-position relay carrier in E-box in plenum chamber,
position 2
contact
Measure to

4 Engine
Groung
- Operate starter briefly.
Specified value: approx. battery voltage
- Carry out following tests:

Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder - Check fuse S234 (in fuse box, position 34).
Pa
ge 18 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2

26-58

- Check for open circuit in wiring from
secondary air injection pump relay (in 3-
position relay carrier in E-box of plenum
chamber) via fuse S234 (in fuse box, position
34) to fuel pump relay.

Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder
Check actuation of secondary air pump relay

- Switch ignition off.

- Remove secondary air injection pump relay.

- Connect voltage tester VAG 1527 B as follows:3-position relay carrier in E-box in plenum chamber,
position 2
contact
Measure to

6 Engine
Ground
- Initiate output Diagnostic Test Mode (DTM) and activate secondary air
injection pump relay.

LED must flash.
Pa
ge 19 of 26 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.26.2