AUDI A4 1996 B5 / 1.G Suspension Tie Rod Remove And Install Workshop Manual
Page 1 of 4
48-14
Tie rods, removing and
installing
WARNING!
Do not re-use any fasteners that are worn or
deformed in normal use.
Some fasteners are designed to be used only
once, and are unreliable and may fail if used
a second time. This includes, but is not
limited to, nuts, bolts, washers, circlips and
cotter pins. Always follow the
recommendations in this manual-replace
these fasteners with new parts where
indicated, and any other time it is deemed
necessary by inspection.
Special tools, test equipment and auxiliary
items
VAG1923
Notes:
Left and right-hand tie rods are identical.
Tie rods can be removed and installed with the
steering gear installed.
Removing
Pa
ge 1 of 4 Tie rods, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.48.3
Page 2 of 4
- Remove front wheel.
- Loosen bolts -3- and -4- and disconnect tie rod end downward.
Pa
ge 2 of 4 Tie rods, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.48.3
Page 3 of 4
48-15
- Remove plastic nut -1-.
- Pry out clips -2-.
- Remove cover for tie rod.
- Open clamps on boot.
Pa
ge 3 of 4 Tie rods, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.48.3
Page 4 of 4
48-16
Installing - Move boot outward as far as possible.
- Remove tie rod using VAG1923.
- Install tie rod.
Tightening torque: 100 Nm (74 ft lb)
- When installing boot, make sure to check:
Smaller diameter of boot clips into groove on tie rod
Boot is not twisted
- Replace inner (large) clamp.
- Check wheel alignment page 44
-6 .
Pa
ge 4 of 4 Tie rods, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.48.3