AUDI A4 1997 B5 / 1.G 01V Transmission Electrical And Electronic Components Owner's Manual

Page 21 of 23

01-31


IThe relay is located on the central electric.
For relay assignment
Electrical Wiring Diagrams, Troubleshooting & Component Locations Fig. 14 Starting interlock relay -J207

Located in instrument cluster
Removing and installing transmission range selector lever display
Repair Manual, Electrical Equipment, Repair Group 90
Fig. 15 Transmission range selector lever display -Y6-
Pa
ge 21 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

Page 22 of 23

01-32


Engines without E-Gas:
The kick-down switch is integrated in the accelerator cable in the plenum
chamber, behind bulkhead -arrow-.
Engines with E-gas:
The kick-down switch is integrated in the throttle position sensor and
Sensor 2 for Accelerator Position (-G79-, -G185-).
A learning procedure must be performed for the shift point of the kick
down switch for engines with E-gas. If the throttle position sensor (-G79-, -
G185-) is removed, exchange the engine control module or disconnect
the battery. Learning procedure can be found in Repair Manual, Fuel
Injection & Ignition, Repair Group 24; Kick down shift point, checking.
Kick-down switch, removing and installing
Repair Manual, Fuel Supply System, Repair Group 20, accelerator pedal mechanism, repairing Front and All Wheel Drive
Fig. 16 Kick-down switch -F8-
- To remove and install the kick down switch, the accelerator cable must
be removed and installed and then adjusted or the throttle position
sensor (38-G79-, -G185-) must be replaced.
Pa
ge 22 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

Page 23 of 23

01-33


The brake light switch -arrow- is located on the pedal cluster.
Brake light switch, removing and installing
Repair Manual, Brake System, Repair Group 46

Note:
For engine with E-gas, the brake light signal is transmitted from the
engine control module to the transmission control module via the CAN-
Bus. Fig. 17 Brake light switch -F-
Pa
ge 23 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

Page:   < prev 1-10 11-20 21-30