transmission AUDI A4 1997 B5 / 1.G 01W Transmission Input Shaft Adjusting Workshop Manual

35-17


Input shaft, adjusting

Note:
The input shaft must be re-adjusted if the
transmission housing, input shaft or ball bearing
is replaced.

Special tools and equipment

30-100 press tube
3167 spacer gauge
Depth gauge

Calculating dimension -x- - Clamp input shaft in vice using protective jaws -A-.
- Place 3167 spacer gauge onto 3rd gear.
- Place transmission housing over input shaft onto spacer gauge.

- Place depth gauge onto transmission housing and measure to lower
circlip groove of input shaft.
Pa
ge 1 of 5 In
put shaft, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.35.2

35-18


Determining circlip thickness behind the input shaft ball bearing - Place depth gauge onto transmission housing and measure to seating
surface for ball bearing.
Measurement in the following example: -b- = 26.80 mm (1.055 in.)
Formula:
x = a - b
Example:

Dimension -a- 28.50 mm
- Dimension -b- 26.80 mm
= Dimension -x- (thickness of circlip) 1.70 mm
- Determine circlip thickness according to table Page 35
-19
.
For part number parts catalog
Pa
ge 3 of 5 In
put shaft, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.35.2