instrument panel AUDI A4 1997 B5 / 1.G APB Engine Additional Signals Checking Workshop Manual

24-183

- Take vehicle for a test drive and check whether
vehicle speed appears in display field 3.

- If vehicle speed does not appear, raise the
vehicle (preferably using a lift) until front left
wheel is clear of the ground.

Electrical Wiring Diagrams, Troubleshooting & Component Locations - Connect VAG1598/31 test box to wiring harness for engine control
module. Do not connect to the engine control module itself Page 24
-
20
.
- Connect diode test lamp between socket 3 (B+) and socket 54 (vehicle
speed signal).
- Switch ignition on and turn front left wheel by hand.
The diode test lamp should flash (very brief flashes).
- If diode test lamp does not flash, check for open circuit or short to B+
or Ground (GND) in wiring between instrument panel and terminal 54
on engine control module connector.
Pa
ge 6 of 37 Additional si
gnals, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.6