lights AUDI A4 1997 B5 / 1.G AWM Engine Camshaft Timing Control Workshop Manual
Page 5 of 7
15-96
If the LED does not light up:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder
If the LED lights up: - Connect voltage tester VAG 1527 B as follows:Connector
contact
Measure to
1 Engine Ground
- Operate starter briefly.
LED should light up.
- Check wiring from contact 1 on connector via fuse to fuel pump relay
for open circuit:
- Correct open circuit, if necessary.
- Check actuation.
Pa
ge 5 of 7 Camshaft timin
g control, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.15.3
Page 6 of 7
15-97
Checking actuation
- Connect voltage tester VAG 1527 B to contacts 1 (positive) and 2 of
connector.
- Initiate output Diagnostic Test Mode (DTM) and activate solenoid valve
for camshaft adjuster.
Output Diagnostic Test Mode Camshaft timin
g control
Display
If the LED lamp does not flash or if it lights up continuously:
Repair Manual, 1.8 Liter 4
-Cyl. 5V Turbo Fuel Injection & Ignition,
Engine Code(s): AWM, Repair Group 24
LED should flash.
- Connect the VAG 1598/31 test box to wiring harness leading to engine
control module (the engine control module should not be connected):
Pa
ge 6 of 7 Camshaft timin
g control, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.15.3