transmission AUDI A4 1997 B5 / 1.G AWM Engine Readiness Code Workshop Manual
Page 9 of 43
01-84
      
Readiness code, generating
 
     
Special Tools and Equipment  
    
Requirements 
Important note:  
If, during a work step, the test result is indicated as "OK" immediately after 
selecting a display group, the test has already been carried out and it is 
OK to continue on to the next work step. 
VAG1788/10 RPM adjusterVehicle stationary Vehicles with automatic transmission Selector lever in P or N. Electrical consumers switched off (radiator fan must NOT run during 
test). A/C switched off. Coolant temperature at least 80  C   Display group 004, display 
field 3. Important: Drive engine warm via road test if possible. 
Pa
ge 9 of 43 Readiness code
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.7 
Page 18 of 43
01-91
      
Work step 4: Kick down function, adapting
1) 
     
1) Only vehicles with automatic transmission  
     
Test requirement:  
     
Engine not running, ignition switched on. 
    
Display on VAS5051:  
Note:  
There will be a prompt: "Operate kick down". 
Note:  
During adaptation of the kick down point, "Kick down ADP in progress" will 
be indicated in display. After successful adaptation of the kick down point, 
"Kick down ADP OK" will be indicated on display.  - 
Press   button 3 times to change into display group 063.-  Depress accelerator pedal completely, past kick down point, and hold 
down. 
-  Check specified value in display field -4-.
Pa
ge 18 of 43 Readiness code11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.7 
Page 21 of 43
01-93
      
Work step 5: Check operating condition of 
oxygen sensor control 
     
-  Start engine (for a vehicle with manual 
transmission: engage clutch). 
     
Note:  
     If necessary, vehicle system "01 - engine 
electronics" and diagnostic function "04 -basic 
setting" must be selected again after engine 
start. 
     
-  Install VAG1788/10 RPM adjuster on the 
accelerator pedal and raise the engine speed to 
2600 RPM. 
     
Test requirement:  
     
Engine running at 2600 RPM. 
    
Display on VAS5051:  
- 
Click on   - button
Pa
ge 21 of 43 Readiness code11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.7