engine AUDI A4 1997 B5 / 1.G Starter Workshop Manual
Page 2 of 8
27-41
      
Vehicles with 4-cylinder gasoline 
engines
 
     
Removing  
    
Vehicles with air conditioning 
 Repair Manual Body Exterior, Repair Group 63
   
 Repair Manual Body Exterior, Repair Group 50    -  Remove noise insulation panel (arrows).
-  Remove front bumper. 
-  Move lock carrier into service position.
Pa
ge 2 of 8 Starter, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.3 
Page 5 of 8
27-44
      
Installing  
      Installation is the reverse of removal; noting the 
following:  
     
Vehicles with air conditioning 
     
-  Install ribbed belt for air conditioning 
compressor. 
    
All vehicles  -  Place torque wrench on hex head of belt tensioner as shown and 
tighten to 25 Nm (18 ft lb). 
-  Maintain torque on belt tensioner and tighten bolt -A- to 20 Nm (15 ft 
lb). 
-  Start engine and make sure belt runs properly.
Pa
ge 5 of 8 Starter, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.3 
Page 6 of 8
27-45
      
Vehicles with 6-cylinder gasoline 
engines
 
     
Removing  
     
Note:  
     To remove the starter, it is first necessary to 
remove the generator   Page 27
-26
 . 
     
2.7 L/184 kW engine, 5V twin-turbo only 
    
All vehicles  -  Remove air duct -1-. 
2 - Attachment point for oil and refrigerant lines
3 - Engine block mounting point
4 - Hose clamp (loosen) 
    
-  Disconnect wire from terminal 30/B+ -2- by removing nut. Tightening 
torque: 16 Nm (12 ft lb) 
-  Disconnect harness connector from terminal 50 -2-.
Pa
ge 6 of 8 Starter, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.3 
Page 8 of 8
27-47
      
Vehicles with automatic transmission 
     
- Remove right-front wheel. 
    
Installing   -  Upper bolt -1- can be unscrewed from right-front wheel housing.
   Tightening torque: 65 Nm (48 ft lb)
-  From engine side, remove lower bolt.
   Tightening torque: 65 Nm (48 ft lb)
-  Remove starter toward front.
-  Install starter in reverse order of removal.
Pa
ge 8 of 8 Starter, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.3