maintenance AUDI A4 1997 B5 / 1.G Three Way Halogen Headlights Workshop Manual
Page 2 of 16
94-2
 
  
Notes: 
 Repair Manual, Maintenance
     
Some procedures could affect the headlight 
beam adjustment, requiring that it be reset   
Page 94
-8 . 
 Adjusting spray for headlights washer nozzles 
 Page 92
-17
 . 
1 - 
Diffuser lens 
2 - 
Retaining clamps (7x) 
To remove, carefully pry out using 
screwdriver To install, press in by hand
3 - 
Headlight frame Locked within headlight housing
4 - 
Seal for lens Always replace
5 - 
Reflector To remove, clip out of retaining ringsTo install, carefully press into retaining 
rings Do not touch inside of reflector
Pa
ge 2 of 16 Headli
ghts, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.94.1 
Page 4 of 16
94-4
      
High intensity gas discharge (Xenon) 
headlights, overview
 
     
CAUTION! 
     
Disconnect the battery Ground (GND) strap 
before working on the electrical system. 
     
Notes:  
     
Before disconnecting the battery, determine the 
correct coding for the anti-theft radio. 
     After reconnecting the battery, check and 
activate the vehicle's electrical equipment 
(radio, clock, comfort and convenience 
features, etc.) as outlined in this Repair Manual 
or the Owner's Manual. 
     Some procedures could affect the headlight 
beam adjustment, requiring that it be reset   
Page 94
-8 . 
     
       Repair Manual, Maintenance
   
     
Adjusting spray for headlights washer nozzles 
 Page 92
-17
 . 
Pa
ge 4 of 16 Headli
ghts, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.94.1 
Page 8 of 16
94-8
      
Headlights, adjusting
 
      Instructions and specifications on headlight 
adjustment:  
     
       Repair Manual, Maintenance
   
     
Notes:  
     
For vehicles with high intensity gas discharge 
(Xenon) headlights, the Diagnostic Trouble 
Code (DTC) memory must be checked and 
erased before each manual adjustment of the 
adjusting screws. The basic adjustment is then 
carried out.  Headlight automatic vertical aim 
control On board Diagnostic (OBD), initiating, 
Page 01
-217
 . 
     
The aimer must be used for the adjustment.
     
       Repair Manual, Maintenance
   
Pa
ge 8 of 16 Headli
ghts, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.94.1