AUDI A4 1998 B5 / 1.G 01A Transmission Pinion Shaft Remove And Install User Guide

Page 11 of 13

39-143


Fig. 9 Installing small tapered roller bearing outer race
- Oil outer race, and position using VW408A punch and 30-205 thrust
pad.

WARNING!
Wear protective gloves. Fig. 10 Installing small tapered roller bearing inner race
- Insert pinion shaft with new spacer sleeve.
-
Heat small tapered roller bearing inner race to approx. 100 C (212 F)
and install onto pinion shaft. - Lift up pinion shaft and press bearing using 40-21 sleeve up to stop.
Pa
ge 11 of 13 Pinion shaft, removin
g, installin
g and servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.16

Page 12 of 13

39-144


Note:
If the specified friction torque is exceeded, the spacer sleeve must be
replaced and the adjustment repeated. A spacer sleeve that has been
over-compressed at any time cannot be reused. Fig. 11 Tightening nut for pinion shaft and measuring friction
torque
- Attach 3304 using two M8 x 30 hex-head bolts.
- Final drive must be supported when tightening nut (e.g. using
VAG1359/2 universal transmission attachment in combination with
VAG1383A transmission jack).
- Replace nut for pinion shaft.
- Tighten nut for pinion shaft, until no more play can be felt on pinion
shaft.
- Increase tightening torque until specified friction torque is attained,
measuring friction torque several times during this process Fig. 12
.
Pa
ge 12 of 13 Pinion shaft, removin
g, installin
g and servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.16

Page 13 of 13

39-145


1) Must have run at least 50 km (30 miles) Fig. 12 Measuring friction torque
A - Torque gauge, 0-600 Ncm (53 in. lb) (commercially available)
B - Socket attachment, 32 mm
- Following friction torque should be set:
New bearings
Used bearings1)
200-250 Ncm (18-22 in. lb) 30-60 Ncm (3-5 in. lb)

Fig. 13 Securing pinion shaft nut
- Secure pinion shaft nut using mandrel.
Pa
ge 13 of 13 Pinion shaft, removin
g, installin
g and servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.16

Page:   < prev 1-10 11-20