fuel AUDI A4 1998 B5 / 1.G AFC Engine Assembly Workshop Manual
Page 1 of 20
10-1
Engine, removing and
installing
Rules of cleanliness
CAUTION!
Whenever carrying out work on the fuel
supply and fuel injection systems, carefully
observe the following five rules of
cleanliness.
1 - Thoroughly clean fuel system line and hose
connections and the surrounding area before
disconnecting.
2 - Place removed components on a clean
surface and cover. Use plastic sheeting or paper.
Do not use fluffy rags that could leave lint!
3 - Carefully cover over or seal any components
that have been opened if repairs are not carried
out immediately.
4 - Install only clean parts:
Do not remove replacement parts from the
packaging until immediately before they are to
be installed.
Do not use parts that have been stored without
packaging (e.g. in toolboxes, etc.).
Pa
ge 1 of 20 En
gine, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.10.1
Page 2 of 20
5 - When the fuel system is opened:
Avoid working with compressed air whenever
possible.
Avoid moving the vehicle if possible.
Pa
ge 2 of 20 En
gine, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.10.1
Page 3 of 20
10-2
Safety precautions
WARNING!
Be sure the ignition is switched OFF, when:
Disconnecting ignition wires
Disconnecting fuel injection system wiring
Connecting or disconnecting test equipment
leads
Disconnecting the battery
Washing the engine or engine
compartment.
CAUTION!
BEFORE disconnecting the battery:
Stop the engine.
Be sure the ignition is switched OFF (also
applies when connecting the battery). Failure
to do so may damage the Engine Control
Module (ECM).
Pa
ge 3 of 20 En
gine, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.10.1
Page 8 of 20
10-6
- Disconnect harness connectors at Mass Air
Flow (MAF) sensor and Idle Air Control (IAC)
valve, unbolt hose from plenum chamber and
unclip.
- Disconnect hose connection at IAC valve.
- Remove air guide between air cleaner and
throttle body.
- Remove air cleaner housing.
- Disconnect fuel supply and return lines.
- Remove coolant expansion tank.
- Remove cover for electronics box.
- Unclip engine control module and disconnect harness connectors.
- Disconnect harness connectors at connector station below engine
control module.
- Disconnect ground connection and bracket for harness connectors at
plenum chamber.
- Disconnect both coolant lines to heater core between plenum chamber
and engine.
- Disconnect accelerator pedal cable and let hang free.
Pa
ge 8 of 20 En
gine, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.10.1