tow bar AUDI A4 1998 B5 / 1.G Airbag Service Workshop Manual
Page 46 of 75
69-77
WARNING!
WARNING!
Make sure no one is in vehicle. 8 -
Bar in connector
Installing:
To ensure that the side airbag functions
properly, when working on backrest cover,
always install new upholstery clips in the
same locations they were removed from.
Only use seat covers approved for use with
side airbags.
- Install harness connector -2- at same
location as when removed and ensure
that bar -8- points toward tunnel.
- Switch ignition on.
- Close doors.
- Connect battery Ground (GND) strap.
Pa
ge 46 of 75 Airba
gs, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.69.3
Page 54 of 75
69-84
- When installing, make sure bar -2- points toward
tunnel.
- After installing sensor mat, test sensor mat
function using VAG1551 Scan Tool (ST) page
69
-84
.
Testing sensor mat function
Note:
Illustration is shown without cover.
- Remove any seat mats before testing sensor
mats.
- Connect
VAG1551
scan tool
Repair Manual, Body
On Board Diagnostic (OBD), Repair Group 01
.
-
Select
Read
Measuring
Value
Block
(function
Pa
ge 54 of 75 Airba
gs, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.69.3