reset AUDI A4 1998 B5 / 1.G APB Engine Motronic Syst

01-100

The readiness code will be reset to "1 1 1 1 1
1 1 1" if:

The DTC memory was erased
A new Engine Control Module was installed
If the voltage supply has been disconnected
from the Engine Control Module (ECM)
In this case the readiness code must be
generated Page 01
-105
.
During driving operation in various load
conditions, exhaust relevant tests are performed
by the control module within a "short trip" and
readiness code is generated on its own. In this
case, however, concluding control possibilities
are not available, meaning that it will not be
indicated whether all positions of the readiness
code are set to "0."
Pa
ge 121 of 166 Motronic s
ystem, On Board Dia
gnostic
(OBD
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.01.1

01-102


Display fields

1 2 3 4
Display Group 086: Readiness code
Display
0 0 0 0 0 0 0 0 X X X X X X X X X X X X X X X X
X X X X X X X X
Indicated
Ready-bits
completed tests Cycle-Flags
Performed cycles Cycle-Flags
Performed cycles Cycle-Flags
Performed cycles
Work area
1 = not completed
0 = completed 1 = not completed
0 = completed 1 = not completed
0 = completed 1 = not completed
0 = completed
Specified value
0 0 0 0 0 0 0 0 X X X X X X X X X X X X X X X X X X X X X X X X
Note:
Readiness code significance on next pages Note for display field 1:
This display field indicates which diagnosis was checked last after the DTC memory was erased or if the control module was
replaced. After erasing the DTC memory, all values that can be checked will be reset to 1, after successful testing these
values will be reset to 0.
Pa
ge 123 of 166 Motronic s
ystem, On Board Dia
gnostic
(OBD
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.01.1

01-107

Work step 2: Erase DTC Memory

Test requirements

Ignition switched on
Rapid data transfer
HELP
Select function XX

When indicated on display
Note:
When DTC memory is erased, readiness code is reset and must therefore
be re-generated. - Press button -0- and -5- to select function "Erase DTC Memory" and
press -Q- button to confirm input.
Rapid data transfer DTC memor
y is erased

When indicated on display
-
Press button.
Pa
ge 129 of 166 Motronic s
ystem, On Board Dia
gnostic
(OBD
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.01.1