battery AUDI A4 1998 B5 / 1.G EVAP Workshop Manual
Page 31 of 65
20-156
Checking output wiring (vehicles with
electronic throttle control)
- Connect voltage tester VAG1527B as follows:Electrical connector terminal
Specification
2 Battery Positive
- Initiate Diagnostic Test Mode (DTM) Page 20
-146
.
-
Press button until following display is shown:
Output Diagnostic Test Mode LDP leak test
Indicated on display:
If LED does not blink:
LED must blink
- Switch ignition off.
Pa
ge 31 of 65 EVAP s
ystem, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.5
Page 33 of 65
20-158
- Connect test box VAG1598/22 to harness connector. The ground
clamp (not visible in the illustration) must be connected to battery
ground connection. Do not connect ECM.
- Check the following wire connection for open circuit or short circuit to
Ground or plus (B+): Electrical connector terminal
Test box VAG1598/22 socket
2 25
- Repair wiring or short circuit if necessary.
Pa
ge 33 of 65 EVAP s
ystem, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.5
Page 52 of 65
20-173
If flow stops:
- Replace EVAP purge regulator valve -N80- and
repeat test before continuing.
If meter indicates no flow after test:
- Perform a quality check and return vehicle to
customer.
If flow continues, proceed as follows:
Method 1: Locate leak with smoke generator
- Connect leads from smoke generator to vehicle
battery.
- Use smoke generator trigger to charge fuel
system with smoke.
- Inspect complete EVAP system for escaping
smoke.
Pa
ge 52 of 65 EVAP s
ystem, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.5