brake AUDI A4 1998 B5 / 1.G Suspension Front Mounting Bracket Remove And Install Workshop Manual
Page 3 of 10
40-70
- Detach ABS wheel speed sensor wire from
bracket on brake caliper.
CAUTION!
Install a support device (e.g. VAG1383A
transmission jack) to prevent damage to the
lower link joints resulting from excessive
rebound travel in the suspension.
- Remove bolt -1- attaching suspension strut to lower track control link.
- Swing wheel bearing housing aside.
- Remove bolts -1- in plenum chamber.
- Remove suspension strut together with mounting bracket.
Pa
ge 3 of 10 Mountin
g bracket, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.40.6
Page 8 of 10
40-74
CAUTION!
The bonded rubber bushings can only be
turned to a limited extent. The bolted
connections on the suspension links should
therefore only be tightened when the vehicle
is standing on the ground.
- Attach lower end of suspension strut to lower track control link with bolt
and new nut and tighten nut -1- to 90 Nm (66 ft lb).
- Remove any residue from threads of ball joint.
- Tighten nut on ball joint to 100 Nm (74 ft lb).
- Install both upper links and tighten nut -2-.
Tightening torque: 40 Nm (30 ft lb)
When tightening, press upper links downward as far as possible
- Attach ABS wiring to retainer on brake caliper.
- Install wheel.
- Check front suspension alignment and, if necessary, adjust using
VW/Audi-approved wheel alignment equipment.
Pa
ge 8 of 10 Mountin
g bracket, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.40.6