boot AUDI A4 1998 B5 / 1.G Suspension Wheel Alignment Workshop Manual
Page 37 of 37
44-38
Front axle toe-in, setting
- Loosen lock nut -B-.
Make sure that the boots are not twisted after turning the tie rods
Note:
Twisted boots will wear out quickly.
After tightening lock nut -B- it is possible that the toe value may deviate
slightly.
If the measured toe lies within the tolerances, the adjustment is correct. - Adjust toe on left and right at hex -A-.
- Tighten lock nut -B- and check toe-in again.
Tightening torque: 40 Nm (30 ft lb)
Pa
ge 37 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2