engine AUDI A4 1999 B5 / 1.G 01A Transmission Final Drive Flange Driveshaft Seals Workshop Manual
Page 1 of 7
39-7
Drive flange and driveshaft
seals, replacing
Transmission installed
- Observe general repair instructions Page 00
-
14
.
Special tools and equipment
VW681 extractor lever
30-505 mandrel
30-506B press support
3337 ring spanner 7-piece set for heated
oxygen sensor
VAG1306 drip tray
Removing
4-cylinder engine
- Remove rear section of exhaust system located
rearward of exhaust pipe clamp.
Pa
ge 1 of 7 Drive flan
ge and driveshaft seals, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.2
Page 2 of 7
Repair Manual, Engine Mechanical, Repair
Group 26
Pa
ge 2 of 7 Drive flan
ge and driveshaft seals, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.2
Page 3 of 7
39-8
6-cylinder engine
- Remove Heated Oxygen Sensor (HO2S) from
right exhaust pipe using 3337 ring spanner 7-
piece set and move clear to side.
- Remove heat shield above right drive axle.
Repair Manual, Engine Mechanical, Repair Group 26
All models - Remove right front exhaust pipe with Three Way Catalytic Converter
(TWC) from exhaust manifold (3 nuts, arrows).
- Remove heat shield for driveshaft from Torsen differential cover
(arrows).
Pa
ge 3 of 7 Drive flan
ge and driveshaft seals, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.2
Page 7 of 7
39-12
- Top off and check transmission oil level Page
34
-38
.
- Align exhaust system free of stress.
Repair Manual, Engine Mechanical, Repair
Group 26
Tightening torques
Component
Tightening
torque
Driveshaft to transmission 55 Nm (41 ft
lb)
Heat shield for driveshaft to
Torsen differential cover 25 Nm (18 ft
lb)
Pa
ge 7 of 7 Drive flan
ge and driveshaft seals, re
placin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.2