center console AUDI A4 1999 B5 / 1.G 01V Transmission Select Lever Mechanism Workshop Manual

37-1


Selector lever mechanism,
servicing

WARNING!

Shift selector lever into position "P" and
engage parking brake before working with the
engine running.

Notes:

Lubricate bearing areas and slide surfaces with
polycarbamide grease G 052 142 A2.
Center console must be removed for service
work:

Ignition key removal lock, checking


- Switch ignition key to driving position (ignition
on).

- Depress brake pedal and hold.

Shifting selector lever out of position "P"
must be possible with the button at shift lever
depressed without "sticking".
It must not be possible to remove ignition
Pa
ge 1 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1

37-24

Cover for Tiptronic shift mechanism,
removing and installing


Removing:

- Remove cover of center console above shift
mechanism.

Repair Manual, Body Interior, Repair Group
68; Storage compartments, covers and trim; Center console, removing.


- Selector lever handle, removing page 37
-
22
.

- Shift selector lever into position "P" by pulling
pull rod.

- Switch off ignition.
Pa
ge 27 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1

37-25


Under no circumstances may the four retaining straps (arrow B)
which are visible from top be pried out, otherwise the circuit board
will be destroyed. In addition, the chromed upper part is permanently
bonded to the upper enclosure cover.
Note:
If the four retaining straps (arrow A) cannot be pried out with bent wire or
a hook, the center console must be removed to gain better access. - Carefully pry out the four retaining straps (arrow A) from top using bent
wire or hook (retainer strap are difficult to see from top).
- Remove complete shift mechanism cover upward.

Note:
If the retaining straps are damaged, the upper cover must be replaced
Item , page 37
-27
. - Press release (arrow A) at connector -1- and pull it out of the cover in
direction of arrow -B-.
Pa
ge 28 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1

37-47


Locking cable for Tiptronic shift
mechanism, removing and installing

Removing
Repair Manual, Body Interior, Repair Group 68;
storage compartments/covers; front center console, removing and installing
- Shift selector lever into position "2".
- Note radio code (for vehicles equipped with
coded anti-theft radio).
- Disconnect Ground (GND) strap from battery.
- Selector lever handle, removing page 37
-22
- Front center console, removing
Pa
ge 52 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1

37-51


Repair Manual, Body Interior, Repair Group 69;
Airbag; Steering wheel, removing and installing

Repair Manual, Body Interior, Repair Group 68;
storage compartments/covers; front center console, removing and installing
- Install steering wheel.
- Front center console, installing- Selector lever handle, installing page 37
-22
- Connect battery Ground (GND) strap.
- For vehicles equipped with coded anti-theft
radio, activate code.
Pa
ge 56 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1

37-52


Shift mechanism (without Tiptronic),
disassembling and assembling

The Tiptronic shift mechanism is described on
page 37
-6 .
Note:
For all further work on the shift mechanism, the
front center console must be removed.
Repair Manual, Body Interior, Repair Group 68;
storage compartments/covers; front center console, removing and installing

1 -
Selector lever handle
Press casing item 2 downward, pull out
button at handle up to stop and pull off
handle upward.
2 -
Sleeve Engages in the selector lever handle
Pa
ge 57 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1

37-55


Repair Manual, 5 Spd. Automatic Transmission
01V On Board Diagnostic (OBD), Repair Group 01; On Board Diagnostic (OBD); Read measuring value block
10 -
Locking cable lever
11 -
Shift lock solenoid -N110-
Removing and installing Fig. 3
, page
37
-61

Unclip connector from wiring harness (at
center console) item , page 37
-61

Can be checked via electrical test and read
measuring value block
12 -
Spring bracket
Insert both ends into selector lever
13 -
Locking segment Insert into selector lever together with
spring bracket
Pa
ge 60 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1