fuel pressure AUDI A4 1999 B5 / 1.G AC System On Board Diagnostic Workshop Manual

01-24

VAG1551 scan tool
display Possible cause
Corrective action
00000
No DTC recognized If "no DTC recognized appears after performing repairs, OBD is ended.
00529 2122
Speed information
missing /SP1) - Open circuit in wiring between Engine Control Module
(ECM), instrument cluster and A/C control head -E87-
- ECM and instrument cluster supply an unusable engine
speed signal - Diagnose and repair open circuit in
wiring using wiring diagram
- Read measuring value block
page 01
-63

- Test engine speed signal
Repair Manual, Fuel Injection &
Ignition, Repair Group 24
00532 2234
Supply voltage

Signal too low /SP - Voltage drops in electrical system to levels of less than
9.5 V2)
- Contact resistance in cable connection to A/C
Refrigerant Low Pressure Switch -F73- - Test Generator (GEN) and Voltage
Regulator (VR)
Repair Manual, Engine
Mechanical, Repair Group 27
- Diagnose and repair contact
resistance using wiring diagram
1)This fault may be generated during Output Diagnostic Test Mode (DTM) (no engine speed signal recognized although A/C
compressor speed detected).
2) If voltage at -E87-connector -C3- drops below 9.5 V, compressor switches off for a minimum of 25 seconds. Compressor
switches on again when voltage exceeds 10.8 V.
Pa
ge 31 of 91 A/C s
ystem, On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.01.1