jump start AUDI A4 1999 B5 / 1.G AFC Engine Intake Manifold Change Over Checking Workshop Manual

24-86

Checking vacuum system

- Start engine and let idle for two to three minutes
to build up vacuum.

- Switch ignition OFF.

- Disconnect 2-pin harness connector from intake
manifold change-over valve.

If the vacuum canister returns to its original position, check as follows: - Using jumper wires from connector test kit VW 1594:
- Connect either connector terminal to intake manifold Ground (GND)
point.
- Connect remaining terminal to VAG1348/3A remote control.
- Connect VAG1348/3-2 adapter wire to B+.
- Activate remote for approx. 2 to 3 minutes, during which time vacuum
canister must remain connected.
- Switch ignition OFF.
- Disconnect vacuum lines from intake manifold change-over vacuum
canister.
- Connect US 8026 hand pump to vacuum canister.
- Operate hand pump and note change-over operation.
Pa
ge 3 of 5 Intake manifold chan
ge-over, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.24.24