coolant AUDI A4 1999 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual

13-24

B - Flywheel end

Note:
Replace oil seal together with sealing flange.

Vehicles with manual transmission

- Drain off coolant Page 19
-19
.

- Remove transmission.

Repair Manual, 6 Spd. Manual Transmission
01E, Repair Group 34


- Remove clutch.

- With crankshaft at TDC, screw in clamping bolt 3242.
- Mark position of flywheel relative to engine -arrows-.
- Remove dual-mass flywheel.
- Remove sealing flange.
Pa
ge 11 of 26 C
ylinder block, crankshaft and fl
ywheel, disassembl
y and assembl
y
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.13.2

13-26

Vehicles with automatic transmission

- Remove transmission.

Repair Manual, 5 Spd. Automatic
Transmission 01V, Repair Group 37


- Drain off coolant Page 19
-19
.

Note:
Turn over the engine at the central bolt on the crankshaft.
CAUTION!
Injury risk - do not turn engine while feeling for TDC drilling. - Turn crankshaft to TDC by hand. Marks -A- and -B- must be aligned.
- Check position of camshafts: larger holes in securing plates on
camshaft sprockets must align opposite one another on inside. If this is
not the case, turn crankshaft one revolution further.
- Remove sealing plug from cylinder block, left.
- The TDC drilling in crankshaft must be visible (or able to be felt) in line
with sealing plug hole.
Pa
ge 13 of 26 C
ylinder block, crankshaft and fl
ywheel, disassembl
y and assembl
y
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.13.2