wheel torque AUDI A4 1999 B5 / 1.G APB Engine Lubrication System Components Workshop Manual
Page 2 of 74
17-2
Crankcase breather and oil spray jets,
removing and installing
Removing and installing oil pump, oil pan, oil filter
and oil cooler Page 17
-32
1 -
Bolt, tightening torque: 20 Nm
2 -
Washer
3 -
Tensioning roller
4 -
Bolt, tightening torque: 45 Nm
5 -
Idler wheel
For toothed belt
Pa
ge 2 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1
Page 41 of 74
17-39
- Disconnect cable from terminal 30/B+ -1-. Tightening torque: 16 Nm
- Disconnect connector for terminal 50 -2-.
- Remove right wheel
- remove top bolt -1- from right wheel housing. Tightening torque: 65 Nm
- Remove lower bolt (accessible from engine side). Tightening torque: 65
Nm
- Remove starter from front of vehicle.
Pa
ge 41 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1
Page 46 of 74
17-44
- Clean both sealing surfaces for lower section of
oil pan; ensure that they are free of oil and
grease.
Note:
Do not use any adhesive or sealant.
- Install new gasket on lower section of oil pan
and install on upper section of oil pan with two
diagonally opposite bolts.
- Tighten all securing bolts hand-tight.
- Tighten bolts to 10 Nm with torque wrench,
working from center outward.
- Install new seal on oil drain plug and tighten to
30 Nm.
Notes:
When installing the upper section of the oil pan
with the engine removed from the vehicle,
ensure that the oil pan is positioned flush with
the cylinder block at the flywheel end.
The sealant must be left to dry for about 30
minutes after installing the oil pan before engine
Pa
ge 46 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1