engine AUDI A4 1999 B5 / 1.G APB Engine Secondary Air System User Guide

Page 21 of 29

26-49

Check activation of the Secondary Air
Injection (AIR) pump relay

- Switch ignition off.

- Remove Secondary Air Injection (AIR) pump
relay.

- Connect VAG 1527B voltage tester as follows:

3-socket relay carrier in E-box,
plenum chamber, position 2
terminal
Measure
to

6 B+

- Initiate output Diagnostic Test Mode (DTM) and
activate Secondary Air Injection (AIR) pump
relay -J299-.

Repair Manual, 2.7 Liter V6 5V BiTurbo Fuel
Injection & Ignition, Engine Code(s): APB, Repair Group 01



LED must blink.
If LED does not blink:
Pa
ge 21 of 29 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.26.2

Page 23 of 29

26-50

- Connect VAG 1598/31 test box at wiring
harness to ECM, do not connect ECM.

Repair Manual, 2.7 Liter V6 5V BiTurbo Fuel
Injection & Ignition, Engine Code(s): APB, Repair Group 24


- Check following wire connection for open circuit
and short circuit to Ground (GND) and B+:

3-socket relay carrier in E-
box, plenum chamber,
position 2
terminal
VAG 1598/31
test box
Bushing
6 46

- Repair open circuit or short circuit if
necessary.
If no malfunctions are detected:

- Replace Secondary Air Injection (AIR) pump
relay -J299-.
Pa
ge 23 of 29 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.26.2

Page 24 of 29

26-51

Check voltage supply of the Secondary Air
Injection (AIR) pump motor

- Remove connector for Secondary Air Injection
(AIR) pump motor -V101-.

- Connect VAG 1527B voltage tester between
terminals 1 and 2

- Initiate output Diagnostic Test Mode (DTM) and
activate Secondary Air Injection (AIR) pump
relay -J299-.

Repair Manual, 2.7 Liter V6 5V BiTurbo Fuel
Injection & Ignition, Engine Code(s): APB, Repair Group 01



LED must blink
Pa
ge 24 of 29 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.26.2

Page 25 of 29

26-52
If LED does not blink:

- Perform following tests marked with dots:

Check wire connection from connector at
Secondary Air Injection (AIR) pump motor-
V101- to Secondary Air Injection (AIR) pump
relay -J299- (in 3-socket relay carrier in E-
Box, plenum chamber, position 2) for open
circuit.

Electrical Wiring Diagrams, Troubleshooting &
Component Locations

Check wire connection from connector at
Secondary Air Injection (AIR) pump motor -
V101- to Ground (GND) connection 1 in
engine compartment wiring harness for open
circuit:

Electrical Wiring Diagrams, Troubleshooting &
Component Locations
If no malfunctions are detected:

- Replace Secondary Air Injection (AIR) pump
motor -V101-.
Pa
ge 25 of 29 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.26.2

Page 26 of 29

26-53

Combination valve, checking


Special tools and equipment

Test requirements:
VAG 1390 Hand Vacuum PumpNo leaks in vacuum lines or hose connections. Vacuum lines not clogged.

- Remove bolts (arrows) and remove engine covers -A- and -B-.
Pa
ge 26 of 29 Secondar
y air s
ystem
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.26.2

Page:   < prev 1-10 11-20