steering AUDI A4 1999 B5 / 1.G Brake Pedal Remove And Install Workshop Manual
Page 2 of 10
46-47
CAUTION! - Secure steering column with safety wire before removing steering
column from steering gear pinion.
The splines between the top and bottom part of the steering
column must not be separated during the removal and installation
procedure. Turn the steering wheel into center position and do not alter
position during repairs, otherwise the airbag spiral spring may be
damaged.
- Move universal joint down out of the way.
Pa
ge 2 of 10 Brake
pedal, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.7
Page 4 of 10
46-49
Installing
CAUTION!
Do not remove safety wire or other
removal/installation aids from steering
column until after the universal joint has been
re-installed on the steering gear pinion.
- Install pedal assembly onto joint pin.
Note:
Do not tighten hex socket-head bolt (arrow) for attaching pedal assembly
to instrument panel member until after installing the brake servo unit.
After installing: - Install hex socket-head bolt (arrow) for attaching pedal assembly to
instrument panel member and tighten by hand.
- Attach accelerator pedal (AP) cable.
- Install brake servo unit page 47
-37
.
- Bleed brakes page 47
-23
.
- Bleed clutch Repair Manual, Manual Transmission 012 Front
Wheel Drive or Manual Transmission 01A All Wheel Drive, Repair
Group 30. -
Adjust brake light switch ( page 46
-50
) and CCS vent valves (
Pa
ge 4 of 10 Brake
pedal, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.7