AUDI A4 1999 B5 / 1.G Quattro Fuel Syst

20-92

Removing

CAUTION!

Obtain the radio Anti-theft code from the
customer before disconnecting the Battery
Ground strap.

Note:
The fuel tank must not be filled to more than
1/3 maximum. - Disconnect Battery Ground strap with ignition switched OFF.
- Open fuel tank cover briefly and close again.
- If necessary, drain fuel tank using fuel cart Page 20
-66
.
- Remove connector flange cover under luggage compartment trim.
Pa
ge 41 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-93

WARNING!

Fuel system is under pressure! Before
opening, place clean cloths around the
connections to be opened. Carefully loosen
the connections to relieve pressure.

- Mark return line -2- and supply line -3- and disconnect from cover
flange.
- Unlatch and disconnect 4-pin harness connector -1-.

- Unscrew union nut using 3217 wrench .
- Remove cover flange and sealing ring from fuel tank opening.
- Disconnect fuel level display harness connector on inside of flange
cover.
- Disconnect return line on inside of cover flange (press unlatching
buttons).
Pa
ge 42 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-94


- Insert 3307 wrench through fuel tank opening and place over the inner
section of the surge housing.
-
Using 3307 wrench, turn inner section of surge housing approx. 15 to
the left up to the stop and withdraw fuel pump assembly complete with
the inner housing section.
Pa
ge 43 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-95

Cover flange and surge housing inner
section, pre-assembling
If cover flange and supply unit were separated

- Pre-assemble parts Page 20
-78
.

Note:
Install a toothed washer beneath each nut.
Angle position, cover flange to inner section of surge housing: 10
- Press together clamps for supply line (between pump and cover flange)
with VAG1275 pliers.
- Attach wiring to fuel pump.
M4: 1.5 Nm M5: 2 Nm
- Attach wiring with fuel-resistant cable ties.
Pa
ge 44 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-96

Installing
Installation is performed in the reverse of
removal, when installing, note the following:

CAUTION!

Always refer to the latest parts catalog to
ensure that you use original equipment fuel
hose clamps.

- Install surge housing inner section, supply hose
and cover flange in the fuel tank.

Note:
For clarity, the surge housing outer and inner sections are shown in the
illustration without the fuel tank. - Place inner section of surge housing into outer section of surge
housing in tank such that notch -1- on inner section of surge housing
matches mark -2- on outer section of surge housing.
The inner section of the surge housing can be audibly pressed
downward.
- Attach 3307 pump wrench and turn surge housing inner section to the
right approx. 15 (up to the stop). Notch -1- will then be in front of mark -3- (bayonet closure)
Pa
ge 45 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-97


Note: - When installing, turn cover flange in direction of arrow to the right as
shown in the illustration.
- Connect the return line inside on the cover flange.
Always use new O-rings. Lubricate O-rings with fuel or coat with lubricant.Install new cover flange gasket (dry) in fuel tank opening.
- Wrap sender for fuel gauge wire once around the supply line (in fuel
tank) and install on cover flange.

Note:
-Arrow 3- only applies to vehicles with front-wheel drive. - Attach cover flange to fuel tank
Vehicles with all wheel drive: arrow 1 must be opposite arrow 2
Pa
ge 46 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-98


Note:
Ensure that fuel hoses fit tightly.
Radio operating instructions - Tighten union nut with 3217 wrench.
60 Nm
- Connect wiring and harness connector.
- Connect Battery Ground strap with ignition switched OFF.
- After connecting Battery, input radio anti-theft code
- Run door windows up to stop using electric window lifters.
- Operate all window lifters again for at least 1 second in "closed"
position to activate automatic up/down.
- Set the clock.
Pa
ge 47 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-99

Sender for fuel gauge -G, checking


Vehicles with all wheel drive and 1.8 ltr. turbo
or 2.8 ltr. engine

Required special tools, testing equipment
and auxiliary equipment

Fluke 83 multimeter
VW 1594 Adaptor kit

- Remove connector flange cover under luggage
compartment trim.

- Unlatch and disconnect 4-pin harness connector -1-.
Pa
ge 48 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-100


Note: - Measure resistance at terminals -2- and -3- on cover flange
Sensor
Tank full
Tank empty
Sender for fuel gauge -G
40
280
If fuel level falls between "Tank full" and "Tank empty", resistance
value between the two specified values must be displayed. If 0 or is displayed there is an open or closed circuit in tank
wiring. To check "Tank full" or "Tank empty" resistance values; remove
sender for fuel gauge -G Page 20
-101
and swing sensor float to top
or bottom stop.
Pa
ge 49 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-101

Sender for fuel gauge -G, removing and
installing


Vehicles with all wheel drive and 1.8 ltr. turbo
or 2.8 ltr. engine
Observe Safety measures Page 20
-1 .
Observe Rules of cleanliness Page 20
-4 .

Removing

CAUTION!

Obtain the radio Anti-theft code from the
customer before disconnecting the Battery
Ground strap.

Note:
Fuel tank must not be filled higher than
1/3 maximum. - Disconnect Battery Ground strap with ignition switched OFF.
- Open fuel tank cover briefly and close again.
- If necessary, drain fuel tank using fuel cart Page 20
-66
.
Fuel supply unit, removing Page 20
-91
.
Pa
ge 50 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3