ECU AUDI A4 2000 B5 / 1.G 01W Transmission Differentila Disassemble And Assemble Workshop Manual

39-21


15 -
Roll pin
For securing differential bevel gear shaftVersion with annular groove: Removing
and installing Fig. 13

Version without annular groove: drive out
using drift
16 -
Small differential bevel gear Installing Fig. 12
17 -
Thrust washer assembly
Lubricate with transmission fluid before
installing
Pa
ge 8 of 15 Differential, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.4

39-27


WARNING!
Wear protective gloves! Fig. 11 Installing ring gear
- When installing ring gear guide with centering pins -A- (local
manufacture).
-
Heat ring gear to approximately 100 C (212 F) and install.- Before installing bolts, allow ring gear to cool a bit. Then tighten to
specified torque.

Fig. 12 Installing differential bevel gears
- Lubricate one-piece thrust washer with transmission oil before
installing.
- Install large differential bevel gears.
-
Install small differential bevel gears at 180 from their final position
and rotate into place (arrow). - Drive in differential bevel gear shaft to final position and secure.
Pa
ge 14 of 15 Differential, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.4