AUDI A4 2000 B5 / 1.G 01W Transmission Oil Level Check Workshop Manual

34-36


Transmission oil level,
checking

Special tools and equipment

17 mm wrench insert hex socket
or
3357 triple square socket driver

Notes:
Vehicle must be level when checking
transmission oil level. This can be achieved
using a pit or 4-post lift.
The oil filler plug is on left side of the
transmission underneath the engine speed
(RPM) sensor, and may be concealed by a heat
shield over the drive axle.

Depending on the version installed, use either 3357 triple square
socket driver or a 17 mm hex socket to loosen the oil drain plug.
Pa
ge 1 of 2 Transmission oil level, checkin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.3

34-37


Note:
Service departments may fill oil up to bottom of oil filler hole. - To check oil level, remove oil filler plug (arrow).
- Check oil level with hand-made tool, e.g. bent wire.
Specification: oil 7 mm (0.276 in.) below bottom of filler hole.
- Top off transmission oil if necessary.
Specification Page 00
-3 .
- Install oil filler plug.
Tightening torque: 25 Nm (18 ft lb).
Pa
ge 2 of 2 Transmission oil level, checkin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.3