sensor AUDI A4 2000 B5 / 1.G 01W Transmission Pinion Shaft Ring Gear Adjustment Workshop Manual

39-54


- Press in tapered roller bearing outer race into differential cover without
shim S1 Fig. 9
, Page 39
-26
.
- Install differential into transmission housing without Vehicle Speed
Sensor (VSS) -G22- gear drive. Ring gear is located on left side in front
of final drive cover.
- Install cover for differential and tighten four bolts to 25 Nm (18 ft lb).
- Position transmission so that cover for differential faces upward.
- Turn differential 5 rotations in each direction to seat tapered roller
bearing.

Note:
Tip of dial indicator must be positioned on the center of the differential. - Assemble measuring equipment, use 30 mm dial indicator extension.
- Set dial indicator (3 mm measuring range) -A- to 0 with 2mm preload.
Pa
ge 32 of 43 Pinion shaft and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.5