catalytic converter AUDI A4 2000 B5 / 1.G 01W Transmission Remove And Install Workshop Manual

34-22


6-cylinder engine - Unbolt right transmission support together with bonded rubber mount
(arrows).
- Loosen clamping sleeves of exhaust system and slide toward Three
Way Catalytic Converter (TWC).
- Remove Three Way Catalytic Converter (TWC) together with exhaust
pipe from below.
- Remove heat shields above left and right drive axles.

Repair Manual, Engine Mechanical, Repair Group 26 - Unbolt front exhaust pipes together with Three Way Catalytic
Converters (TWCs) from left and right exhaust manifolds (3 nuts on
each side) (arrows).
Pa
ge 5 of 20 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.2

34-35

Component

Tightening
torque
Drive axle to flange
shaft M8 40 Nm (30 ft
lb)

M10 77 Nm (57 ft
lb)
Engine Speed (RPM) sensor -
G28- 10 Nm (7 ft
lb)
Clutch slave cylinder to
transmission
Socket-head bolt 1) 20 Nm (15 ft
lb)
Bolt 2) 25 Nm (18 ft
lb)
Heat shields over drive axles to
transmission 23 Nm (17 ft
lb)

Shift rod to transmission 1) 20 Nm (15 ft
lb)
Pivot rod to transmission 40 Nm (30 ft
lb)
Three Way Catalytic Converter
(TWC) to mounts 25 Nm (18 ft
lb)
Front exhaust pipe to
turbocharger or exhaust 25 Nm (18 ft
lb)
Pa
ge 19 of 20 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.2