diagram AUDI A4 2000 B5 / 1.G AFC Engine Control Module Voltage Supply Checking Workshop Manual

28-27


Engine Control Module (ECM)
voltage supply, checking

Note:
To check the ECM voltage supply Repair
Group 01, Read measuring value block, display
group 001, display field 4.
Fuse for ECM OK

- Connect test box VAG 1598/19 to ECM wiring
harness page 01
-255
.

- Switch ignition on.

- Connect VAG 1527B voltage tester between test
box socket D10 (B+) and Ground (GND).

Voltage tester must light up
If voltage tester does not light up:

If voltage tester lights up: - Check for open circuit using wiring diagram, and repair as necessary.
-
Connect voltage tester between test box socket D10 (B+) and then in
sequence to test box Ground (GND) sockets A19, D3, D7, D12, E3, E7
Pa
ge 1 of 3 En
gine Control Module
(ECM
) volta
ge su
pp
ly, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.28.8

28-28
If voltage tester does not light up:

If voltage tester does not light up: - Check wiring using wiring diagram and eliminate open circuit if
necessary.
- Connect VAG 1527B voltage tester between test box socket B10 (B+)
and engine Ground (GND).
Voltage tester must light up
- Check wiring between ECM connector B terminal 10 and central
electrical panel using wiring diagram and, if necessary, eliminate open
circuit.
Pa
ge 3 of 3 En
gine Control Module
(ECM
) volta
ge su
pp
ly, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.28.8