tow AUDI A4 2000 B5 / 1.G Engine Oil Level Checking Workshop Manual
Page 69 of 111
69
Setting low beam alignment of driver's side
headlight
- Move Beamsetter into position in front of the
vehicle so it is aligned with the vehicle and
Beamsetter box is 30 to 70cm (12 to 28 in.) from
the driver's side headlight.
- Switch headlights ON in low beam position.
- Align Beamsetter box so it is centered on the
headlight (align vertically then horizontally).
Note:
Use the arrows on the Beamsetter box as a
guide.
You may want to use a straight edge or tape
measure, because alignment must be within
3cm (1.2 in.) of the center of the headlight.
- Without moving the Beamsetter, slide Broad-
band sight toward center of vehicle (Broad-band
sight can also be moved up and down for a
better position).
Use Broad-band sight to make final alignment of
Beamsetter box to vehicle by:
Pa
ge 69 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6
Page 106 of 111
101
Transportation wiper blades, removing
Transportation blades can easily be removed as
follows:
- Grasp blade as shown and rotate in direction of arrow (toward
windshield).
Note:
Wiper arm/blade alignment has been preset at the factory, then checked
and adjusted (if necessary) during the PDI.
DO NOT twist or bend the wiper arm. If wiper arm/blade alignment is
incorrect, chattering and/or streaking will occur.
Transportation wiper blades, removing (A4) - Rotate blade in opposite direction (black arrow) then, carefully slide
blade off wiper arm.
-
New style original equipment blade (already installed on wiper arms),
Pa
ge 106 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6