AUDI A4 2001 B5 / 1.G 01V Transmission Drive Shaft Service Owner's Manual
Page 21 of 23
39-91
Available adjustment shims
Distance -a-
(mm) Shim thickness
(mm)
0 to 3.0 -
3.1 to 5.0 2
5.1 to 7.0 4
7.1 to 9.0 6
9.1 to 11.0 8
11.1 to 13.0 10
- Install left and right shims determined from
table.
Pa
ge 21 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5
Page 22 of 23
39-92
Centering driveshaft lengthwise
- Slide driveshaft with alignment fixture toward rear to stop.
- Mark position of center support on body (arrow A).
- Slide driveshaft with alignment fixture toward front to stop.
- Mark position of center support on body -(arrow B).
- Center driveshaft (arrow C):
Center support must be centered between markings -A- and -B-.
- Install mounting bolts for driveshaft center support and the pre-
determined shims and tighten.
- Remove alignment fixture.
- Install heat shield above driveshaft.
Pa
ge 22 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5
Page 23 of 23
39-93
Installation is reverse of removal, noting the
following:
- Install exhaust system free of stress:
Repair Manual, Engine Mechanical, Repair
Group 26; removing and installing exhaust
system
Tightening torques
Component
Nm
Center driveshaft support to body 23
Crossmember to body 25
Nuts for clamping sleeve 40
Pa
ge 23 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5