AUDI A4 2001 B5 / 1.G 01V Transmission Final Drive Gear Oil Workshop Manual

39-1


Gear oil in front final drive

Gear oil in front final drive, checking


Special tools and equipment

VAG1306 drip tray

3247 plug insert (8mm)
-
Perform a short road test to heat up gear oil to approx. 60 C.
- Drive the vehicle onto a 4-column lift or over a work pit so that it is
absolutely level.
- Switch engine off and let gear oil drip out for 5 minutes.
- Place VAG1306 drip tray underneath.
Pa
ge 1 of 4 Gear oil in front final drive
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.1

39-2


Note:
Loosen locking bolt using an angled socket-head wrench, but do not use
3247 hex ball socket. For improved accessibility it may be necessary to
remove the heat shield and drive axle and to set them aside.
If 3247 hex ball socket is used for loosening the bolt, it could be
destroyed. - Remove oil filler plug (arrow).

Specification: Oil level should reach lower edge of oil filler hole.
- Let excessive gear oil drain or top up gear oil.
Specification page 00
-22
- Always replace O-ring for oil filler plug.
- Tighten locking bolt using 3247 hex ball socket (8mm socket) to 30
Nm.
Pa
ge 2 of 4 Gear oil in front final drive
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.1

39-3

Gear oil in front final drive, filling up
after repair


Special tools and equipment

VAG1306 drip tray
- Drive the vehicle onto a 4-column lift or over a work pit so that it is
absolutely level.
- Place VAG1306 drip tray underneath.

Note:
Loosen locking bolt using an angled socket-head wrench, but do not use
3247 hex ball socket. For improved accessibility it may be necessary to
remove the heat shield and drive axle and to set them aside.
If 3247 hex ball socket is used for loosening the bolt, it could be
destroyed. - Remove oil filler plug (arrow).
Pa
ge 3 of 4 Gear oil in front final drive
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.1

39-4

- Slowly and uniformly fill front final drive over a
time period of at least 5 minutes until gear oil
escapes at lower edge of oil filler hole.


Specification page 00
-22

Note:
Filling time of at least 5 minutes is essential, so
that the internal oil level compensation between
differential and retaining area can occur.

- Install old oil filler plug.

- Perform a short road test to heat up gear oil to
approx. 60 C.
- Make sure to check oil level in front final drive
page 39
-1 !
Pa
ge 4 of 4 Gear oil in front final drive
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.1