torque AUDI A4 2001 B5 / 1.G 01V Transmission Oil Pan And Oil Strainer Assembly Workshop Manual
Page 20 of 44
38-20
 
    
Installing  
Installation is reverse of removal, noting the following:  
Note:  
Drain plug and oil seal must both be replaced.  
Tightening torques   -  Remove ATF drain plug -1- and drain ATF.
-  Loosen bolts of oil pan in diagonal sequence.
-  Clean all 4 magnets in oil pan recesses. Ensure full surface contact of 
the magnets on the oil pan. 
- Replace gaskets.
-  Fill up ATF   page 37
-140
 .
Component  
Nm  
Drain plug to oil pan   40  
Oil pan to transmission housing  
(diagonally in sequence)    
10  
Pa
ge 20 of 44 Oil 
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1 
Page 21 of 44
38-21
      
Oil strainer, removing and installing
 
     
Removing  
     
- Removing oil pan   page 38
-19
 .
    
Installing  
Tightening torque   -  Removing oil strainer bolts (arrows).
-  Pull oil strainer off of valve body.
-  Lightly coat seal on suction collar of oil strainer with ATF.
-  Carefully press suction collar of oil strainer into the opening at valve 
body up to stop. 
-  Bolt on oil strainer.
-  Installing oil pan   page 38
-20
 .
-  Fill up ATF   page 37
-140
 .
Component  
Nm  
Oil strainer to valve body   6  
Pa
ge 21 of 44 Oil 
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1 
Page 28 of 44
38-28
      
All: 
    
Tightening torque   -  Connect clip to wiring harness connector (arrow).
-  Installing oil strainer   page 38
-21
 .
-  Installing oil pan   page 38
-20
 .
-  Fill up ATF   page 37
-140
 .
Component  
Nm  
Valve body to transmission housing (from inside out)   8  
Pa
ge 28 of 44 Oil 
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1 
Page 34 of 44
38-34
 
    
Tightening torques   -  Rotate switch until the alignment hole -4- at switch housing can be 
fitted on the alignment pin -2- at transmission housing. 
-  Installing left transmission support   page 37
-125
 .
Component  
Nm  
multi-function Transmission Range (TR) switch -F125- to 
transmission    
8  
Pa
ge 34 of 44 Oil 
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1 
Page 38 of 44
38-38
      
For transmissions with hydraulic control 
E18/2  
     
Removing  
     
-  Removing valve body   page 38
-22
 .
    
Installing   -  Unbolt Sensor for transmission RPM -A- from transmission.
-  Bolt on Sensor for transmission RPM -A- at transmission via bolt -B-. 
Tightening torque is 9 Nm. 
Pa
ge 38 of 44 Oil 
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1