oil AUDI A6 1995 C5 / 2.G 01E Transmission Final Drive Rear Remove And Install Workshop Manual

39-105


Note:
The cross member -1- need not be removed.
Installing
Installation is carried out in the reverse order, when doing this observe the
following:
Note: - Unscrew securing bolts -B- and -C- of rear cross member on rear final
drive.
- Lower final drive on transmission jack.
Always replace self-locking nuts.It is essential to clean out the locking fluid remaining in the threads in
the drive flange on the rear final drive after removing the driveshaft.
Otherwise there is a danger that the new bolts will seize when they
are screwed in and then shear if they have to be removed later. The threaded holes can be cleaned with a thread tap.Replace gasket between driveshaft and drive flange (pull off backing
foil and stick gasket onto drive flange). Surface must be free of
grease. Replace driveshaft bolts (self-locking).
Pa
ge 4 of 8 Rear final drive, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.14

39-107

- Check gear oil in rear final drive Page 39
-
80
.

- Align exhaust system free of stress.

Repair Manual, 2.7 Liter V6 5V
BiTurbo
Engine Mechanical, Engine Code(s): APB, Repair Group 26


Tightening torques

Component

Nm
Driveshaft to final drive
(drive flange) 55
Front cross member for rear final drive to
body 40
Front cross member for rear final drive and
exhaust bracket to body 23
Rear cross member for rear final drive to
subframe
50
Rear cross member to rear final drive
55
Pa
ge 6 of 8 Rear final drive, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.14