fuel AUDI A6 1996 C5 / 2.G ATQ Engine Output Diagnostic Test Mode Workshop Manual
Page 1 of 12
01-56
 
     
Output Diagnostic Test Mode 
(DTM) (function 03) 
     
Notes:  
     
Output Diagnostic Test Mode (DTM) is only 
possible with engine idle and ignition switched 
on. 
     Output Diagnostic Test Mode (DTM) is aborted 
if engine is started or an RPM signal is 
recognized. 
     In output Diagnostic Test Mode (DTM), 
individual actuators (with the exception of the 
fuel injectors) are activated for approximately 1 
minute unless the next actuator is selected 
earlier by pressing the " button. 
     Actuators are checked either acoustically or by 
touch. 
     The electric Fuel Pump (FP) runs during all of 
output Diagnostic Test Mode (DTM). 
     Engine must be started before repeating output 
Diagnostic Test Mode (DTM). (ECM must 
recognize an engine speed of above 300 RPM).
Pa
ge 1 of 12 Out
put Dia
gnostic Test Mode 
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3 
Page 2 of 12
01-57
       Output Diagnostic Test Mode (DTM) activates 
the following components in the specified 
sequence:  
     
Activation sequence  
1   Evaporative Emission (EVAP) canister purge 
regulator valve -N80-  
2   Secondary Air Injection (AIR) solenoid valve 
-N112-  
3   Secondary Air Injection (AIR) pump relay -
J299-  
4   Intake manifold change-over valve -N156-  
5   Camshaft adjustment 1 (Valve 1 for camshaft 
adjustment -N205- and valve 2 for camshaft 
adjustment -N208-)  
6   Leak Detection Pump (LDP) tank ventilation 
system  
7   Cylinder 1 fuel injector -N30-  
8   Cylinder 4 fuel injector -N33-  
9   Cylinder 3 fuel injector -N32-  
10   Cylinder 6 fuel injector -N84-  
11   Cylinder 2 fuel injector -N31-  
12   Cylinder 5 fuel injector -N83-  
Pa
ge 2 of 12 Out
put Dia
gnostic Test Mode 
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3 
Page 3 of 12
01-58
      
Test requirement:  
     
Fuses for engine electronics OK 
     
Test sequence  
     
-  Connect VAS5051 tester or VAG1551 scan tool 
and select the control module for engine 
electronics using "address word" 01   Page 01
-
9 . 
     
   Ignition must remain switched on for this.Rapid data transfer  
HELP
Select function XX
    
When indicated on display:  
-  Press buttons -0- and -3- to select "output Diagnostic Test Mode" and 
press -Q- button to confirm input. 
Rapid data transfer 
Q
03-Output Dia
gnostic Test Mode
    
Indicated on display:  
Activating the EVAP canister purge regulator valve (tank vent valve)  
Note:  
The Fuel Pump (FP) relay must trigger, the Fuel Pump (FP) must run, 
flowing noise at fuel pressure regulator is clearly audible. If Fuel Pump 
(FP) does not run, check activation   Page 24
-52
 .  -  Confirm input using the -Q- button.
Pa
ge 3 of 12 Out
put Dia
gnostic Test Mode 
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3 
Page 8 of 12
01-62
      
Note:  
     The click can be heard by listening near the rear 
left wheelhousing. 
      If valve is not activated (does not click):  
     
       Repair Manual, Fuel Supply System, Repair 
Group 20; components of the EVAP canister system, servicing; Leak Detection Pump (LDP) 
-
V144
-, checking.
   
     
Activating fuel injectors  
     
Note:  
     Fuel injectors are activated according to ignition 
sequence: Cyl. 1, Cyl. 4, Cyl. 3, Cyl 6 Cyl. 2, Cyl 
5. 
     
- 
Press button.Output Diagnostic Test Mode Cyl. 1 fuel injector -N30
    
Indicated on display:  
- 
Press button.
Output Diagnostic Test Mode Cyl. 1 fuel in
jector -N30
    
Indicated on display:  
   Fuel injector must click 5 times after arrow button is pressed.
Pa
ge 8 of 12 Out
put Dia
gnostic Test Mode 
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3 
Page 9 of 12
If injector does not click:  
-  Check fuel injectors   Page 24
-36
 .
Pa
ge 9 of 12 Out
put Dia
gnostic Test Mode 
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3 
Page 10 of 12
01-63
      
- 
Press button.Output Diagnostic Test Mode Cyl. 4 fuel injector -N33
    
Indicated on display:  
- 
Press button.
Output Diagnostic Test Mode Cyl. 4 fuel in
jector -N33
    
Indicated on display:  
If injector does not click:     Fuel injector must click 5 times after arrow button is pressed.
-  Check fuel injectors   Page 24
-36
 .
- 
Press button.
Output Diagnostic Test Mode Cyl. 3 fuel in
jector -N32
    
Indicated on display:  
- 
Press button.
Output Diagnostic Test Mode Cyl. 3 fuel injector -N32
    
Indicated on display:  
If injector does not click:     Fuel injector must click 5 times after arrow button is pressed.
-  Check fuel injectors   Page 24
-36
 .
Pa
ge 10 of 12 Out
put Dia
gnostic Test Mode 
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3 
Page 11 of 12
01-64
      
- 
Press button.Output Diagnostic Test Mode Cyl. 6 fuel injector -N84
    
Indicated on display:  
- 
Press button.
Output Diagnostic Test Mode Cyl. 6 fuel in
jector -N84
    
Indicated on display:  
If injector does not click:     Fuel injector must click 5 times after arrow button is pressed.
-  Check fuel injectors   Page 24
-36
 .
- 
Press button.
Output Diagnostic Test Mode Cyl. 2 fuel in
jector -N31
    
Indicated on display:  
- 
Press button.
Output Diagnostic Test Mode Cyl. 2 fuel injector -N31
    
Indicated on display:  
If injector does not click:     Fuel injector must click 5 times after arrow button is pressed.
-  Check fuel injectors   Page 24
-36
 .
Pa
ge 11 of 12 Out
put Dia
gnostic Test Mode 
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3 
Page 12 of 12
01-65
      
- 
Press button.Output Diagnostic Test Mode Cyl. 5 fuel injector -N83
    
Indicated on display:  
- 
Press button.
Output Diagnostic Test Mode Cyl. 5 fuel in
jector -N83
    
Indicated on display:  
If injector does not click:     Fuel injector must click 5 times after arrow button is pressed.
-  Check fuel injectors   Page 24
-36
 .
Output Diagnostic Test Mode END
    
Indicated on display:  
- 
Press button.
Rapid data transfer 
HELP
Select function XX
    
Indicated on display (function selection):  
Note:  
Before re-initiating output Diagnostic Test Mode (DTM), engine must be 
started and the ignition must be switched off and on again. 
Pa
ge 12 of 12 Out
put Dia
gnostic Test Mode 
(DTM
) (function 03
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.3