diagram AUDI A6 1996 C5 / 2.G ATQ Engine Oxygen Sensor Control Checking
Page 56 of 63
24-121
Checking voltage supply for oxygen sensor
heating
Test requirement:
Fuse for oxygen sensor heating OK
Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder
Fuel Pump (FP) OK, checking Page 24
-
49
.
Component location of harness connectors
Overview of component locations, page Page
24
-5
- Disconnect 4-pin harness connector leading to
respective oxygen sensor.
- Connect multimeter between terminal 1 and 2 for voltage
measurement.
Pa
ge 56 of 63 Ox
yg
en sensor control, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.3
Page 59 of 63
24-123
If there is no voltage again:
- Check wire connection from terminal 1 to Fuel
Pump (FP) relay via fuse for open circuit.
Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder If voltage supply is OK:
If there is no voltage: - Connect multimeter for voltage measurement as follows:Harness connector
Terminal
Measure
to
2 (Ground -GND- activation of Engine Control Module -
ECM-) B+
- Start engine.
Specification: approx. battery voltage, possibly fluctuating
- Switch ignition off.
- Connect VAG1598/31 test box at wiring harness to ECM, do not
connect ECM Page 24
-17
.
Pa
ge 59 of 63 Ox
yg
en sensor control, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.3