check engine AUDI A6 1997 C5 / 2.G AEB ATW Engines Cylinder Head Remove And Install Workshop Manual
Page 32 of 35
15-30
Compression, checking
Special tools and equipment
VAG1381 or VAG1763 compression tester
3122B spark plug removal tool
Test condition
Minimum engine oil temperature: 30 C (86
F)
Test procedure
- Remove engine covers.
- Switch ignition off and remove harness
connectors to ignition coils.
- Unbolt ignition coils (arrows).
- Remove all harness connectors to fuel injectors.
- Using 3122B spark plug removal tool, remove all spark plugs.
- Open throttle to Wide Open Throttle (WOT) position.
- Using VAG1381 or VAG1763 compression tester, test engine
compression.
Pa
ge 32 of 35 C
ylinder head, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.2
Page 34 of 35
15-31
- Activate starter until no further pressure
increases are indicated by VAG1381 or
VAG1763 compression tester.
Compression pressure
Engine code
New
Wear limit
AEB 10.0-13.0 bar
(145-188.5 psi) 7.0 bar
(101.5 psi)
Permissible difference between all cylinders: 3
bar (43 psi)
- Install spark plugs and ignition coils.
- Check DTC memory.
Repair Manual, 1.8 Liter 5V Turbo Fuel
Injection & Ignition, Repair Group 01
Note:
Diagnostic Trouble Codes (DTCs) are stored
when harness connectors are disconnected.
After testing, check DTC memory and erase.
Pa
ge 34 of 35 C
ylinder head, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.2