bolt pattern AUDI A6 1997 C5 / 2.G AHA ATQ Engines Cylinder Block Crankshaft And Flywheel Component Service Manual

13-23

Driveplate

- Hold crankshaft in position using 3242
crankshaft holder page 13
-12
.

- Mark hole pattern of driveplate, shim -1- and
washer -2- to crankshaft.

- Mark positions of shim -1- and washer -2-
(behind driveplate).

CAUTION!
Part numbers are listed here for reference only. Always check with
your Parts department for the latest information.
Notes: - Install driveplate with washer -2- (Part No. 035 105 303 A) and shim -1-
3.0 mm (Part No. 054 105 301) or 4.0 mm (Part No. 054 105 202).
Short engines and exchange engines are supplied without a bushing
in the crankshaft. Always install a new bushing before installing the
driveplate. Remove bushing using 21/1 Kukko puller and 21/2 Kukko support.Always replace driveplate mounting bolts.
Component
Tightening torque
Driveplate to crankshaft
30 Nm (22 ft lb) + 90
Pa
ge 22 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2