spark plugs AUDI A6 1997 C5 / 2.G AHA Engine Motronic Ignition System Workshop Manual
Page 1 of 34
28-1
 Motronic ignition system Technical data, spark plugs
 
Engine code  
AHA  
  
Engine idle RPM  
 
Idle RPM cannot be adjusted, is corrected by Idle Air Control (IAC) 620 - 740 RPM  
(all-wheel drive)    
   740 - 860 RPM  
(front-wheel drive)    
RPM limit  
 Operates by shutting off fuel injectors approx. 6500 RPM     
Ignition timing  
 Ignition timing cannot be adjusted; it is determined by the Engine Control Module (ECM)     
Firing order  1-4-3-6-2-5     
Spark plugs   Tightening torque   30 Nm (22 ft lb)     
  Part No. 1)   101 000 035 HJ (NGK)     
   Manufacturer's code  
(if applicable)  BKR 6 EKUB (NGK)     
  
Electrode gap - mm   1.6 mm     
  
Maintenance interval    Owner's Manual  
  
Pa
ge 1 of 34 Motronic i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.28.1 
Page 27 of 34
28-22
      
Checking  
     
-  Check DTC memory   page 01
-16
 .
     
There must be no malfunctions stored 
     
-  If DTC memory is not clear (malfunctions 
recognized): 
     
  -  Make necessary repairs and erase DTC 
memory. 
     
  -  Stop engine and start engine again.
     
 - Road test. 
     
  -  Check and erase DTC memory again.
     
-  By briefly disconnecting fuel injector connectors 
with engine running, check which cylinder is 
misfiring, or not firing at all. 
      A misfiring cylinder can also be isolated by 
examining the spark plugs (for a carbon-fouled 
plug).  
     
- 
Interchange spark plug with one from cylinder 
Pa
ge 27 of 34 Motronic i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.28.1 
Page 29 of 34
28-23
      
Checking ignition coils -N-, -N128- and -N158-
  
     
-  Disconnect 5-pin connector from ignition coil 
assembly. 
     
-  Remove ignition wires from spark plugs.
    
If resistance is NOT OK:  -  Using multimeter and adapters from VAG1594 connector test kit, 
measure resistance between both spark plug connectors of respective 
ignition circuit (across coil). 
  
Specification: approx. 18-25 k .-  Remove ignition wires from ignition coils and measure resistance 
between ends of respective ignition wires. 
  
Specification: approx. 4.0-6.0 k
Pa
ge 29 of 34 Motronic i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.28.1