manual transmission AUDI A6 1997 C5 / 2.G ATW Engine Motronic Fuel Injection Syst

24-26

Installing
Installation is reverse of removal, noting the
following:

Note:
Important note:
After installing new Engine Control Module
(ECM), the following work steps must be
performed:
- Check DTC memory and erase it if necessary
Page 01
-16
.
- Perform adaptation of the Throttle Valve Control
Module -J338- Page 24
-121
.
- Observe notes for coding new Engine Control
Module (ECM) Page 01
-62
.
- For vehicles with cruise control (discernable at
steering column), switch this free in ECM:

Repair Manual, Electrical Equipment On
Board Diagnostic (OBD), Repair Group 01; OBD for cruise control system

- For vehicles with automatic transmission, the
kick down function must be adapted Page 24
-
Pa
ge 27 of 81 Motronic fuel in
jection s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.24.1

24-32

If idle speed is too high or low and there are
no DTCs in DTC memory, the following tests
(marked with dots) must be performed:

Check for false air in intake air system
Page 24
-68
.

Check throttle valve control module Page 24
-120
.

Evaporative Emission (EVAP) canister purge
regulator valve always open, checking
Page 24
-107
.

Perform adaptation of throttle valve control
module Page 24
-121
.
Significance of 5 digit indication of display group 056 x
x
x
x
x
Display field 4
0 A/C compressor: 0 = A/C compressor off; 1 = A/C compressor on
0 Manual transmission: Indication always 0
Driving mode for automatic transmission: 0 = selector lever in P or N; 1 = selector lever in 2/3/4/D/R
0 Indication always 0
0 Indication always 0
0 Indication always 0
Pa
ge 36 of 81 Motronic fuel in
jection s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.24.1

24-33

System pressure, fuel pressure
regulator and residual pressure,
checking


Note:
Fuel pressure regulator regulates fuel pressure
according to intake manifold pressure. This
ensures that the pressure drop at the fuel
injectors remains the same for each speed and
load range of the engine.

Special tools and equipment

Test requirements:
Repair Manual, Fuel Supply System, Repair Group 20

VAG1318V.A.G 1318 with V.A.G 1318/11 adapter, V.A.G 1318/12 pressure
hose with connectors and V.A.G 1318/13 adapter Fuel Pump (FP) relay OK; checking Page 24
-53
.
Fuel Pump (FP) OK, checking: Fuel filter OK Battery voltage at least 12.7 V Vehicles with automatic transmission Selector lever in P or N.
Pa
ge 37 of 81 Motronic fuel in
jection s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.24.1